http://www.AnswerRack.comAsk A Question

  • Have a question?
  • Can't afford to spend hundreds of dollars for a consultant or expert?
  • Just need some advice?
  • Do you need a second opinion?
  • Tired of endless internet searches without an answer?
  • Ask one of our online experts,they are here to help you.
  • Save your money! Ask a question! Enjoy what you have saved!

Recent Questions
Here's what I have so far from chasing the rabbit down the hole... New Autolite Platinum plugs gapp
Here's what I have so far from chasing the rabbit down the hole... New Autolite Platinum plugs gapped .042 <2000 miles on Duralast plug wires New BWD ignition coil pack (twice) New cats y-pipe with 3rd (Unmonitored) deleted New Bank 2 Sen 1&2 O2 sensors New Heated PCV Vacuum runs 19-21.4 at idle. Drops to 0.5-1.0 on take off then to around 12 to maintain on flat ground. Idle in park fluctuates between 650-750rpm Replaced vac line & coupler on the backside of the air intake tube behind the MAF. Ran the smoke/propane/water mist tests, no leaks Barely gets up a small hill going 20 with about 50% throttle. All the while stuttering like it has a bad plug Alt & Batt tested good Belt and tensioner good Shows codes P0353(intermittently) & P1000 (constant, no CEL)
|
Hello- I am working on a Volvo L220G Loader with a hydraulic problem. Pump pressure is erratic afte
Hello- I am working on a Volvo L220G Loader with a hydraulic problem. Pump pressure is erratic after having all three pumps rebuilt...any help with further ideas/diagnostics would be much appreciated! Thanks, Rick
|
O have a AO Smith Powershot FPSH 50 270 . It would keep recycling for 3 attempts then go to Green li
O have a AO Smith Powershot FPSH 50 270 . It would keep recycling for 3 attempts then go to Green light and yellow A&B lights. I would clean the flame sensor with steel wool, put it back in and it would run fine for 3-4 hours then turn off and recycle the same 3 times, no flame ignition. I replaced the flame sensor/ ignitor and it started up normally, 3 hours later it would recycle again with the above mentioned lights on. I "CLEANED" the "NEW" flame sensor rod with steel wool, put it back together and it started normall again, 3-4 hours later it is recycling. How can the gas be affecting a new sensor like this? I clean it and the water tank works for a while? Any help would be appreciated.
|
i need to disable TRC and VSC in my 2008 Toyota hybrid RX 400h lexus
i need to disable TRC and VSC in my 2008 Toyota hybrid RX 400h lexus
|
i need to disable TRC and VSC in my 2008 Toyota hybrid RX 400h lexus
i need to disable TRC and VSC in my 2008 Toyota hybrid RX 400h lexus
|
How much does it cost in total to replace complete front bumper, grille, hood, left fender w/fende
How much does it cost in total to replace complete front bumper, grille, hood, left fender w/fender flare and left headlight. and if all that is needed how much can you negotiate on a car. It is priced at 15,000 but with all repairs, is it a good deal to get the car fixed and buy it at a lower cost?
|
On a 2005 9-5 Saab with a new ac compressor and condensor & dryer, would you expect the degrees cold
On a 2005 9-5 Saab with a new ac compressor and condensor & dryer, would you expect the degrees cold get to 60 or 40F?
|
I am looking for the plastic piece that this is glued to underneath dash.. Its the catch(hook) that
I am looking for the plastic piece that this is glued to underneath dash.. Its the catch(hook) that the glovebox door holds onto.
|
About to purchase new from the Hyundai deslership, either the Creta Fully loaded with *6* airbags &
About to purchase new from the Hyundai deslership, either the Creta Fully loaded with *6* airbags & push start or The Tucson 1.6 Turbo *2* airbags key start. Which vehicle overall would be the safer, considering the frame/body and then the airbags. Kind Regards HeidiHyandai
|
I have a hyundai accent 150GSI 99 Model. this car is giving me lot of problems. It starts, I can go
I have a hyundai accent 150GSI 99 Model. this car is giving me lot of problems. It starts, I can go to work but on my way back home, it just dies. I replace the coil pack and the cam shaft sensor. What else can be wrong?
|

Official PayPal Seal
Email Hosting


Home | Contact Us | Terms Of Service | Privacy Policy | Links |

© 2009 - 2016 AnswerRack.com / All rights reserved